The technology of stickers of vinyl wallpaper includes several stages. First, we prepare the walls, they must be even and dry. Remove the old coating if it is available, wetting the surface with water, and after some time we scatter the material with a spatula. If walls with defects, then they must be treated with putty. And if we glue the wallpaper on a plastic or other smooth surface, first we go.
After the walls are prepared, cut the wallpaper canvases and draw glue, which is well stirred and leave for a while for swelling. Then we lubricate the canvases, leave them for several minutes for impregnation, after which glue on the wall. According to the instructions, for pasting the room with vinyl wallpaper, it is provided that the glue should be applied not only to the strips, but also to the walls.
We begin to glue from the window. Previously drawing a vertical line on the wall, a guideline for the first strip. Next, you need to straighten the wallpaper with a brush from above to the very bottom, and also the movements should be from the center to the edges. Thus, bubbles that can form when gluing are leaving. Cut the wallpaper should be a special sharp paper knife. Stripes are glued to the joint. Glue, which can act at the edges, is necessarily removed by a damp sponge or fabric. When we need to glue the angle, it is better not to bend the whole canvas, but to make a small overlap in a corner by 2-3 cm. For many, there is difficulty in sticker wallpaper in areas of ceiling and skirting boards, there you can use a special line to help, which is a triangular profile with which we adjust and accurately cut the canvas. Thus, the ceiling and skirting boards are not polluted.