To install a wooden door, it is necessary to have special tools, for example, a drill, a screwdriver, as well as a milling cutter to create a nest for a lock. If the purchased door was placed in disassembled, then before the installation process, it is necessary to make sure that the door leaf, the door frame and all the other elements are in integrity. If no defects were found, then you can proceed to direct installation. You need to install the door on the rib and carefully outline the places where the loops will be attached. During the installation of wooden doors, a pair of loops is mounted. If the door is massive, it is recommended to additionally install the third loop.
Then it is necessary to measure about twenty centimeters from the top and the bottom of the door leaf, attach a loop there, and then circle with a pencil. With the help of a chisel, you must carefully hide special grooves for loops, as well as paint them with special wood varnish, which will avoid moisture in the part of the door leaf, which are unprotected. Then it is necessary to try on the loop through which the hole under the screws is inhabited. It is very important to monitor parts of the loops and not confuse them.
On the door leaf, it is necessary to install halves of the loops, which are directed by the pin emerging from them down. After installing the loops on the door leaf, it’s time to start inserting the lock if it is necessary. The castle crashes, as a rule, at a height of about 90 cm from the floor. It is necessary to measure and mark this distance on the door leaf, then attach a lock there and circle it with a pencil. If there is a milling cutter in stock, then it is necessary to use it to create a groove to the depth of the lock.
During the selection of the lock, it must be borne in mind that its depth should be no more than a third of the width from the strapping timber of the door leaf. If this rule does not comply, then there are options for its warping. After preparing the nest for the lock, it must be treated with varnish.
It is necessary to measure the height of the doorway and use the rushed the doorbox racks using. During assembly, screws must be screwed into corner compounds. The door frame is installed in the doorway, after which the level of its verticality is checked, and in the end it is fixed using wedges.