Before proceeding to put the walls, you need to evaluate the condition of the walls that you are going to putty. Spat along the wall along the wall and down, forming small squares, then glue the adhesive plaster or tape and tear off to this place. If large pieces of putty stuck to the tape, then this layer will need to be removed, otherwise it makes no sense to apply a new layer of putty, it simply will not stay on the wall.
Those places where the previous plaster is crumbling should be carefully cleaned and dangled. Inspect the wall, and if there are cracks on it, you need to process these places. You can use the putty mesh, which must be glued along the crack and smear the crack with putty. While the walls are “naked”, you can organize additional sockets or switches, which the tools presented can help in. Previously, you need to cut the groove, lay the cable there, then put it and let it dry.
How to troubles the distance to some inaccessible subject. An innovative laser range finder will come to the rescue. In order to buy a Leica Disto farmer and learn more about it, just look at the page on the Internet .
After processing all potholes and cracks, you can proceed to the priming of the walls. A primer is needed in order to protect the wall from decay and fungus, also in order to increase the clutch of the wall with putty. Knead the putty mass and move on to putty. If the wall is prepared in order to subsequently glue the wallpaper on it, it will be enough to put it with a starting putty.
But if you need to get a smooth surface, then we will put putty in two stages. The first layer – applying a starting putty. Further, applying final putty. After applying each layer, it is necessary that the wall is well dried. After complete drying out to obtain an uniform and smooth surface of the wall, the wall must be cleaned with a skin.